Komatsu 707-98-34710 7079834710 Bucket Cylinder Seal Kit WA150-5 Wheel Loader Lift Inner Parts

Komatsu 707-98-34710 7079834710 Bucket Cylinder Seal Kit WA150-5 Wheel Loader Lift Inner Parts

Countermeasures for oil leakage due to poor sealing:
1. Master and identify the basic knowledge of fake and inferior products, and choose high-quality and standard oil seals.

2. During installation, if the outer surface of the shaft diameter is low in roughness or has defects such as rust spots, rust, burrs, etc., it should be smoothed with a fine emery cloth or oil stone; clean oil or grease should be applied to the oil seal lip or the corresponding position of the shaft diameter. Coat the outer ring of the oil seal with sealant, wrap the key way on the shaft with hard paper to avoid scratching the lip of the oil seal, use a special tool to rotate the oil seal inward, and do not hit hard to prevent the oil seal from deforming or squeeze the spring to fail; if the lip flanges, the spring falls off and the oil seal is skewed, it must be removed and rein stalled. It should be noted that when the shaft diameter is not worn and the elasticity of the oil seal spring is sufficient, do not tighten the inner spring [4] without authorization.

3. Oil seals used on machinery are generally subject to harsh working conditions, large environmental temperature differences, a lot of dust, and frequent machine vibrations, which require frequent inspections, maintenance, and maintenance when the mechanical conditions are constantly changing.

4. If the shaft diameter and bearing wear is severe; the oil seal rubber is aging or the spring fails, etc., repair and replace the corresponding parts in time.

5. Troubleshoot abnormal heating components or assemblies in time; avoid mechanical over speed and overload operation to prevent the oil seal lip temperature from rising, rubber aging, and early lip wear.

6. Always check the oil level of the engine oil. If there are too many impurities in the engine oil, if there are alloy powders or metal iron filings, the engine oil must be completely replaced. The brand and quality of the oil to be changed must meet the seasonal requirements. It is recommended to add metre super sealant & lubricant to the engine oil. It is an excellent gearbox additive that can form a thin film of inert material on the components, which can slow down the leakage of the oil seal and extend the use of the oil seal gear longevity can also reduce the noise of the gearbox. The use of this super seal lubricant will not pollute or deteriorate the oil.

Komatsu WA150-5 model replacement parts:

KOMATSU Seal Kit

Bucket Cylinder Seal Kit

Hydraulic Cylinder Seal Kit

Komatsu 707-98-34710 7079834710 Bucket Cylinder Seal Kit WA150-5 Wheel Loader Lift Inner Parts Images